Double tap to zoom
Reduces fuel consumption, fewer emissions and carbon footprint.
Delivers up to 25% in fuel savings.
Reduce Green House Gases
Fuel saved directly correlates to reduced harmful exhaust emissions, including green house gases.
Easy to Start
Easy start in any altitude or climate condition (no manual choke).
Closed loop (with O2 sensor) monitors combustion and keeps engine running at optimum levels.
Sequential Fuel Injection
Delivers the precise amount of fuel and spark where needed to maximize efficiency and power.
|Steering Control||Hydro drive with Enhanced Control System (ECS), forward/reverse, left/right or zero-turn.|
|Casters||.38" thick caster yoke arms|
|Front Caster Tires||11 x 4.0-5, smooth tread, semi-pneumatic.|
|Drive Tires||18 x 8.5-8, 4-ply Turf Master®|
|Safety Package||Operator Presence Controls (OPC). Operator must have speed control lever in neutral and blades disengaged to leave operator’s position without stopping engine|
|Parking Brake||Lever-actuated mechanical compression.|
|Electrical||12-volt battery with 20-amp alternator.|
|Engine Series||Command™ EFI Propane|
|Engine Speed||3,600 rpm|
|Air Filter||Heavy-duty canister air filtration system|
|Drive Description||Twin Hydro-Gear variable-displacement pumps and twin high-efficiency Parker/Ross wheel-drive motors with 1\\" (2.54cm) tapered shafts.|
|Speed||Infinitely variable speed selection from 0– 6.75 mph (10.9 kmph) forward, 0–2.25 mph (3.6 kmph) reverse.|
|PTO Engagement||Electromagnetic 200 ft-lbs clutch.|
|Fuel Capacity||33.5-lb propane tank|
|Drive Wheel Release||Allows unit movement without engine running.|
|Deck Lift||Manual lift with hairpin from hole to hole for position adjustment.|
|Engine Type||EFI Propane|
|Fuel Type||Propane EFI|
|Deck Style||Floating Deck|
|Deck Style Description||Full-floating UltraCut Series 4. Side discharge standard, with molded discharge chute and option to bag or mulch.|
|Width / Cutting Deck||60"|
|Deck Construction||10-gauge top that is formed and continuously seam welded, 7-gauge side skirt and 10-gauge formed and welded spindle mounting locations for improved strength.|
|Cutting Heights||1.5" (3.8 cm) to 4.5" (11.4 cm) in 0.5" (1.3 cm) increments.|
|Blade Spindles||No maintenance, sealed and non-greasable spindles; 7.75"-diameter cutter housing with 25mm (.98") diameter spindle shaft and splined blade driver.|
|Blade Tip Speed||Approximately 18,500 fpm.|
|Blades||3 Blades at 20.5" Length|
|Width||72.0 in. (182.96 cm)|
|Length||84.8 in. (215.4 cm)|
|Height||45.0 in. (114.3 cm)|